International design conditions for cooling towers: Inlet water temperature t1=37℃; The outlet water temperature t2=32℃; Wet-bulb temperature t=28℃; The dry bulb temperature θ=31.5℃; Atmospheric pressure =9.94 × 10⁴Pa

2. The standard cooling towers of our company are designed in accordance with the national design conditions. We can also provide customers with special and specialized designs for non-standard working conditions

3. Due to site limitations or design requirements, our company can carry out special design and customization according to the dimensions requested by the customer. For more details, please contact us

4. All the supporting surfaces of the foundation should be on the same horizontal plane, and the elevation and dimensional errors should be less than 5mm

5. The height of the cooling tower foundation should be determined based on the diameter of the main outlet pipe and the installation height

When two or more units are assembled, our company will provide connecting balance pipes and balance the water level of the chassis

7. If the user requires our company to increase the diameter of the water outlet flange, please specify this when placing the order

8. The noise measurement point is at the equivalent diameter Dm of the cooling tower

9. The connection chart shows the connection position dimensions of a single unit. The assembly of multiple units is the same as this

When different types of towers are connected, the foundation height must be adjusted according to the water level height of the chassis of different types of towers to maintain the water level balance of each tower

1. Modular design is adopted to optimize the design structure and make the volume more reasonable. Single or multiple units can be flexibly selected according to the installation site. The distance between the air inlet and the air outlet is long, no heat reflux is generated, the heat exchange efficiency is high, and the effect is better in areas prone to freezing in winter.

2. The improved flame-retardant PVC raw material is used as the heat sink material, and the blister mold is formed in one step. It adopts the whole hanging, honeycomb air inlet, and special corrugated structure design. It does not need to be pasted. It has the characteristics of diversion, heat dissipation, water collection, easy cleaning, and convenient disassembly and assembly.

3. The tower frame structure adopts Q235 hot-dip galvanized weldless assembly; the shell (FRP) adopts the latest improved material of Ashland in the United States, with uniform color, difficult to fade, and anti-aging.

4. The cooling effect reaches 105% of the designed cooling effect, the water drift rate is ≤0.001%, the appearance is novel, low noise, small footprint, energy saving and environmental protection, corrosion resistance, and long service life.